PUFP355 W  
       

  • Active PFC
  • Temperature control sensor
  • Over Voltage/Temp/Short circuit protection connector
  • Dual +12V rails (V1 and V2)
    		•
    Dimension
     
    1 x 20+4 pin M/B; 1 x ATX 12V 4 pin, 4 x peripheral connectors, 1 x floppy drive power connector, 2 SATA connector, 1 x PCI connector, 1 x 3 pin fan monitor connector
      Dimension
    Unit Size 150mmx140mmx86mm
    Net Weight 2.25KGS
    Compatible

    Maximum Power
    		 355W      
      I/O switch, 115/230 switch
    Special connectors
    		 1 x 20+4 pin M/B; 1 x ATX 12V 4 pin, 4 x peripheral connectors, 1 x floppy drive power connector, 2 SATA connector, 1 x PCI connector, 1 x 3 pin fan monitor connector
    Transient Responser
    		 Not define in the spec
    P.G. Signaler
    		 TTL compatible. Signal goes high 100-500ms
    Over Voltage Protection recycle AC to reset
    		 The +5V/+12V1/+12V2/+3.3V DC output are protected against the over voltage condition. Maximum value can’t be over 7V at 5V terminal, 15.6V at 12V1 & 12V2, 4.5V at 3.3V.
     
     
    INPUT
    Input Voltage
    		 230V
    Input Frequency
    		 47-63Hz
    Input Surge Current
    		 Less then the ratings of it’s critical components (Including bulk rectifiers. Fuses and surge limiting device).
    Input Current
    		 100A max. When AC input 230Vac at 250C cold start.
    Hold-up Time
    		 >16ms at full load at 115 Vac
    Efficiency
    		 70%(min.) at full load(typical)
    EMI/RFI
    		 FCC Part 15 Class B & CISPR 22 Class B

     

     
    OUTPUT
      +5V +3.3V +12V1 +12V2 -12V +5Vsb    
    Max load
    		 18.0A 21.0A 15.0A 15.0A 0.3A 2.5A    
    Min. Load
    		 0.5A 0.3A 1.0A 1.0A 0.0A 0.0A  
    Load Reg.
    		 +5% ~ -5% +5% ~ -5% +5% ~ -5% +5% ~ -5% +10% ~ -10% +5% ~ -5%    
    Ripple m(p-p) 50mV 50mV 120mV 120mV 120mV 50mV    

     

     
    ENVIRONMENTAL
    Operating Tem.
    		 0°C to 50°C
    Operating Alt.
    		 0-8000feet
    Non-Operating Vibration
    		 Sweep and resonance search for each of X,Y,Z axis at the sweep. Refer the standard IEC 60086-2-6, Rate of 1 / octave / Min
    MTBF
    		 > 100,000 hours at 75% load and 25°C ambient conditions
    Safety Approval
    		 UL(CUL) / TUV / CB / NORDIC
     
    Noise levels
    oV 25 30 35 40 45 50 55 60 65 70 75 80 85 90  
    V                              
    RPM                              
    db