1000W JN128F-1000CAP
       
  • Dual Fan includes one 120mm and one 80mm fan design provides maximum air-flow at lower RPM, delivers extreme silence performance
  • Modular advance cable management.
  • 4 independent +12V output rails ensure safe and stable system operation under heavy operation
  • Ultimate balance between cooling and noise level; Extreme low noise level Smart Fan Control Circuit based on our Automatic Temperature sensor. Increased silence, extended fan life and more reliable performance by eliminating unnecessary high RPM
  • Honey Comb Structure with best ventilation. Optimum structure for best ventilation and maximum airflow to solve potential thermal and noise problems. Reduce the air resistance to minimum.
  • Active PFC,Active Power Factory Correction. Corrects Power factory from typical 50% to theory ideal 99%. Environment friendly technology reduces the cost of electricity and saves you money on facility bill.
  • Compatible with SLI/Intel EPS12V and latest PCI EXPRESS 2.0 (8 pin PCIE connectors)
 

 
 
1 x (20+4) PIN
1 x  EPS 8PIN
4x PCI E 6PIN (4 cables, 1 connector one cable)
2 x PCIE 8PIN cables (2 cables, 1 connector one cable).
1 x  P4 4 Pin,
2 x (SATA+ SATA+SATA)  cables,
total 6 x SATA contacts (3 connectors one cable)
2x  (3 *L4P + 1* S4P ) cables
total 6 *L4P + 2* S4P  (3+1 connectors one cable )

 Dimension
Unit Size

150 x190 x86 mm

Net Weight 3.2KGS
   
Compatible

Maximum Power
 1000W
Hold up time
>16mS at full load 230Vac
Short circuit protection
Latch off
Transient Response
 Not define in the spec
P.G. Signal
 TTL Compatiable signal goes high 100-1000ms
Over Voltage Protection recycle AC to reset

+3.3V: <4.3V
+5V: < 7V
+12V: < 15.6V

 

 
INPUT
Input Voltage
 115-230V
Input Frequency
 50-60 Hz
Input Surge Current
 Less then the ratings of it’s critical components (Including bulk rectifiers. Fuses and surge limiting device).
Input Current
 12A
Efficiency
83%
 
ENVIRONMENTAL
Operating Tem.
 10-30 C
Storage Temp
-20-80c
cooling
Self contained fan with speed control in regard to O/P load or ambient temp
MTBF
>100,000 hours at 75% load and 25cambient condition
Leakage current
 < 3.5mA when power supply connect to 253Vac/50Hz
 
Noise levels
Output Voltage Min Current

Max Current

Regulation

Ripple P-P Max

Ripple &Noise P-P Max  
+5V 0.5A 30A ±5% 70mV 100mV
  • Maximum continuous total DC output power should not exceed 1000W
  • Maximum continuous combined load on +3.3VDC and +5VDC outputs shall nor exceed 170W
  • Maximum combine load on 12V rails output shall not exceed 900W
+12V1 0.5A 20A ±5% 50mV p.p 200mV
+12V2 0.5A 20A ±5% 120mV p.p 200mV
+12V3 0.09A 20A ±5% 120mV p.p 200mV
+12V4 0.1A 20A ±5% 120mV p.p 200mV
-12V 0A 0.5A ±10% 120mV p.p 200mV
+5Vs 0.1A 3A ±5% 50mV p.p 100mV
+3.3V 0.8A 24A ±5% 50mV p.p 100mV